The following guides you have chosen are displayed below:

Netcomm NB11W Hardware Setup Guide For VDSL2

This guide will walk you through setting up the Netcomm NB11W modem for use with the VDSL2 service.

Step 1 - Turning On The Modem Modem Setup
Plug the power adapter to both a power socket and the rear of the modem. The proceed to turn on the modem.
Step 2 - Powering Up The Modem
Allow 60 - 90 seconds for the Netcomm NB11W to power up.
Step 3 - Connecting The Modem To The Phone Socket
Using the phone cable that is supplied with the Netcomm NB11W, connect the modem to the telephone wall socket labelled Internet.
Step 4 - Connecting To The Exchange
Once the phone cable is connected and modem powered on, the VDSL/DSL light on the modem will commence flashing. This indicates that the modem negotiating a connection with the VDSL/DSL equipment at your local telephone exchange. When this negotiation is successfully completed the VDSL/DSL light will remain permanently on.
Step 5 - Authentication
Our Netcomm NB11W manual configuration guide for authentication is located here.
Further Help: If you require further assistance, please contact the Adam Internet Help Desk on (08) 8423 4000 or email help@adam.com.au with as much detail as possible regarding the issue at hand.