The following guides you have chosen are displayed below:
- Hardware Setup
Cisco SRP 521W Hardware Setup Guide For Business WiMAX
This guide will walk you through setting up the Cisco SRP 521W modem for use with the Business WiMAX service.
|Step 1 - Turning On The Router|
Plug the power adapter to both a power socket and the rear of the router. The proceed to turn on the router.
The Cisco SRP 521W has an on / off switch at its rear.
|Step 2 - Powering Up The Router|
|Allow 60 - 90 seconds for the Cisco SRP 521W to power up.|
|Step 3 - Connecting The Router to the Business WiMAX Network|
Using the ethernet cable which is supplied with the Cisco SRP 521W, connect the routers WAN port to the ethernet port on the PoE that was provided upon installation by the technician.
The Radio port must be connected to the wall ethernet socket via an ethernet cable. The installation technician will supply both PoE and ethernet cable.
The ethernet port will have been installed by the technician at installation.
|Step 4 - Connecting To The Network|
|Once the ethernet cable is connected and router powered on, the WAN light on the router will turn on. This indicates that the router is connected to the network.|
|Step 5 - Authentication|
Our Cisco SRP 521W manual configuration guide for authentication is located here.
Further Help: If you require further assistance, please contact the Adam Internet Help Desk on (08) 8423 4000 or email firstname.lastname@example.org with as much detail as possible regarding the issue at hand.