The following guides you have chosen are displayed below:
- Hardware Setup
Netcomm NB16WV Hardware Setup Guide For WiMAX
This guide will walk you through setting up the Netcomm NB16WV modem for use with the WiMAX service.
|Step 1 - Turning On The Router|
Plug the power adapter to both a power socket and the rear of the router. The proceed to turn on the router.
The Netcomm NB16WV has an on / off switch at its rear.
|Step 2 - Powering Up The Router|
|Allow 60 - 90 seconds for the Netcomm NB16WV to power up.|
|Step 3 - Connecting The Router to the WiMAX Network|
Using the ethernet cable which is supplied with the Netcomm NB16WV, connect the routers WAN port to the ethernet port on the PoE that was provided upon installation by the technician.
The Radio port must be connected to the wall ethernet socket via an ethernet cable. The installation technician will supply both PoE and ethernet cable.
The ethernet port will have been installed by the technician at installation.
|Step 4 - Connecting To The Network|
|Once the ethernet cable is connected and router powered on, the WAN light on the router will turn on. This indicates that the router is connected to the network.|
|Step 5 - Authentication|
Our Netcomm NB16WV manual configuration guide for authentication is located here.
Further Help: If you require further assistance, please contact the Adam Internet Help Desk on (08) 8423 4000 or email firstname.lastname@example.org with as much detail as possible regarding the issue at hand.