The following guides you have chosen are displayed below:
- Hardware Setup
Billion 6404VGP R3 Hardware Setup Guide For WiMAX
This guide will walk you through setting up the Billion 6404VGP R3 modem for use with the WiMAX service.
|Step 1 - Turning On The Router|
Plug the power adapter to both a power socket and the rear of the router. The proceed to turn on the router.
The Billion 6404VGP R3 has an on / off switch at its rear.
|Step 2 - Powering Up The Router|
|Allow 60 - 90 seconds for the Billion 6404VGP R3 to power up.|
|Step 3 - Connecting The Router to the WiMAX Network|
Using the ethernet cable which is supplied with the Billion 6404VGP R3, connect the routers WAN port to the ethernet port on the PoE that was provided upon installation by the technician.
The Radio port must be connected to the wall ethernet socket via an ethernet cable. The installation technician will supply both PoE and ethernet cable.
The ethernet port will have been installed by the technician at installation.
|Step 4 - Connecting To The Network|
|Once the ethernet cable is connected and router powered on, the WAN light on the router will turn on. This indicates that the router is connected to the network.|
|Step 5 - Authentication|
Our Billion 6404VGP R3 manual configuration guide for authentication is located here.
|Step 6 - AdamTalk|
To use the AdamTalk service you will need to ensure that you have a landline phone plugged into the Phone 1 port at the back of the modem and have the modem configured with your AdamTalk details.
AdamTalk manual configuration guide can be found here.
Further Help: If you require further assistance, please contact the Adam Internet Help Desk on (08) 8423 4000 or email firstname.lastname@example.org with as much detail as possible regarding the issue at hand.