The following guides you have chosen are displayed below:
- Hardware Setup
Netcomm NP803n Hardware Setup Guide For NBN & Fibre
This guide will walk you through setting up the Netcomm NP803n modem for use with the NBN & Fibre service.
|Step 1 - Turning On The Router|
Plug the power adapter to both a power socket and the rear of the router. The proceed to turn on the router.
The Netcomm NP803n has an on / off switch at its rear.
|Step 2 - Powering Up The Router|
|Allow 60 - 90 seconds for the Netcomm NP803n to power up.|
|Step 3 - Connecting The Router to the NBN & Fibre Network|
Using the ethernet cable supplied with the Netcomm NP803n, connect the router's WAN port to the the data port on the Network Termination Device (NTD) associated with your Adam Internet broadband connection.
Once your Adam Internet broadband service has been provisioned, we will send your mobile phone (if supplied) a text message with information including the NTD port number that has been reserved for your broadband service.
If you continue to be unsure as to what port on the NTD reserved for your Adam Internet broadband connection, please call us on (08) 8423 4000.
|Step 4 - Connecting To The Network|
|Once the ethernet cable is connected and router powered on, the WAN light on the router will turn on. This indicates that the router is connected to the network.|
|Step 5 - Authentication|
Our Netcomm NP803n manual configuration guide for authentication is located here.
Further Help: If you require further assistance, please contact the Adam Internet Help Desk on (08) 8423 4000 or email firstname.lastname@example.org with as much detail as possible regarding the issue at hand.