Netcomm NB9WMAXX Wireless Setup GuideThis guide will walk you through setting up the Netcomm NB9WMAXX modem to get wireless access.
Wireless LAN, sometimes called Wi-Fi is an alternative to connecting your computer to your modem router using an Ethernet cable. It has the benefits of allowing computers connected to the modem router to move around freely within range of the modem. It does however require security to be set up to prevent any unwanted access.
Configuring the Modem for Wireless
- To start, open an internet browser window (Internet Explorer, Mozilla Firefox, Safari, etc.).
- At the top of the browser window is the address bar, this may currently contain a website address such as:
Delete this address entirely and type in the following number:
Press Enter on the keyboard.
- A login prompt will be displayed requesting a username and password. This is the modem username and password and is not to be confused with your Adam username and password.
Enter the username admin and the password admin. Click OK.
- Once the browser has logged in, the modem status page will be displayed. This page contains information about the modem and connection such as firmware version and connection speeds.
On the left hand menu, Click on Wireless.
- This will bring up the Wireless Setup menu. Ensure that Enable Wireless is ticked. In the SSID field, enter the name you wish to call the network (e.g. My Wireless). This name will appear when you search for a wireless network to help you identify which network in the area is yours. To save the name, click Save/Apply.
- Now a security passphrase must be set to prevent unwanted access. Click on the Security option on the left hand menu under Wireless. On this page, enter the following settings and click Save/Apply:
- Select SSID: the network name you chose
- Network Authentication: WPA2-PSK
- WPA Pre-Shared Key: choose a strong passphrase (minimum 8 characters)
- WPA Group Rekey Interval: 0
- WPA Encryption: AES
- WEP Encryption: Disabled
- The modem is now configured to broadcast and connect to wireless computers. If at any point you wish to change the key, simply follow this guide again to update it.
If you wish to disable the wireless network, you can untick Enable Wireless in the Wireless > Setup menu, this will prevent the modem from broadcasting a wireless signal.
Please note that these settings are a guide only. Adam Internet accepts no responsibility for any network or security problems that may arise from weak or incorrectly configured wireless settings. It is your responsibility to ensure that your home network is secure and configured correctly for your hardware.
Connecting to the ModemLocating and connecting to the wireless network will vary from computer to computer based on what operating system it has and whether or not it has a 3rd party connection utility (e.g. Acer eNet Management, Dell WLAN utility, etc.). This part of the guide will show an example of connecting to the wireless network using Windows Vista.
- Locate the network icon in the System Tray. Normally, this will be on the bottom right hand side of the screen near the clock. Right click on the icon and select Connect to a network.
- A window will appear titled Connect to a network. In our example the network is simply called My Wireless. If you have given your network a different name, then that is what you should search for in the list.
Once the network has been located, click on the name to select it and then click Connect at the bottom of the window.
- You will now be prompted for a passphrase, enter in the passphrase you chose when setting up the modem and click Connect. You will only need to do this the first time as the passphrase will be stored for future use until you change it on the modem.
- The computer will now try to connect to the wireless network. If the key is valid and the network is in range it should connect. If the connection was successful, it will display the message Successfully connected to My Wireless.