The following guides you have chosen are displayed below:

Billion 7800VDOX Hardware Setup Guide For Adam Business NBN and Adam Business WiMAX

This guide will walk you through setting up the Billion 7800VDOX modem for use with the Adam Business NBN and Adam Business WiMAX service.

Step 1 - Turning On The Router Hardware Fibre Setup
Plug the power adapter to both a power socket and the rear of the router. The proceed to turn on the router.

The Billion 7800VDOX has an on / off switch at its rear.
Step 2 - Powering Up The Router
Allow 60 - 90 seconds for the Billion 7800VDOX to power up.
Step 3 - Connecting The Router to the Adam Business NBN and Adam Business WiMAX Network
Using the ethernet cable which is supplied with the Billion 7800VDOX, connect the router to the the ethernet wall socket at the premises. Should the premises have multiple ethernet sockets, you will need to establish which socket is connected to the Network Termination Point (NTP). It is typically labelled Internet.

The ethernet port will have been installed during the establishment of the premises. It can sometimes be found in the pantry or laundry. If your're unable to locate your ethernet port, please contact the premises builders.
Step 4 - Connecting To The Network
Once the ethernet cable is connected and router powered on, the WAN light on the router will turn on. This indicates that the router is connected to the network.
Step 5 - Authentication

Our Billion 7800VDOX manual configuration guide for authentication is located here.

Further Help: If you require further assistance, please contact the Adam Internet Help Desk on (08) 8423 4000 or email help@adam.com.au with as much detail as possible regarding the issue at hand.